Fleet Video Accessories

The KP2 replacement installation kit, containing the consumables used up during a fit: cable ties, a Torx key, alcohol preparation pads and 3M adhe...

The KP2 installation tool, used for trim removal and cable routing during a windshield install. Installation tool for KP2 fitting For trim removal ...

The KP2 mounting bracket, supplied with a 2.73m cable. This is the assembly that holds the KP2 to the windshield, and it is a replacement part for ...

A privacy cover for the KP2 driver-facing camera. It physically blocks the lens, which satisfies driver privacy requirements and union agreements i...

The hardwired KP2 power adaptor, connecting to constant power, ignition and ground rather than a diagnostic port. This is the professional install:...

Double-sided 3M adhesive tape for the KP2 mounting pad, supplied as a single piece. Use it when remounting a KP2 to the windshield after removal, s...

A 2m extension cable for the KP2, used where the standard cable run does not reach the chosen power source or the camera needs mounting further fro...

A wireless Bluetooth panic button for KP2 systems. Pressing it flags the moment as an event so the footage is preserved and uploaded rather than ov...

A 2m extension for the KP2 remote interior cameras, doubling the standard 2m lead to 4m. For high-cab vehicles and split-windshield installations w...

The simplest way to power a KP2: plug it into the vehicle's OBD-II port and the install is done. Voltage monitoring handles ignition detection and ...

A cigarette lighter power adaptor for the KP2. The fastest possible installation and fully reversible, which makes it the right choice for leased v...

The heavy-duty KP2 connection, for trucks and equipment with a J1939 nine-pin Deutsch port instead of OBD-II. Acts as a splitter, leaving an open J...

The Xirgo IOX auto-pairing cable, connecting a KP2 or XVD-302 camera to a Geotab GO9 or GO10 telematics device. Auto-pairing means the two devices ...

The driver-facing camera blank plate for the KP2. It fills the module bay on units running road-facing only, keeping dust and debris out. One ships...

A mixed-standard splitter for vehicles carrying both diagnostic types. Takes a female OBD-II input and provides one J1939 female and one J1939 male...

The pass-through version of the KP2 OBD-II power cable. It powers the KP2 while keeping a female OBD-II port available, so a diagnostic tool or a s...

An OBD-II splitter that turns one port into two. Single male OBD-II connector into two female OBD-II connectors, so a KP2 and a second device can s...

An angled block wedge for KP2 installations in trucks with a split windshield. The wedge corrects the mounting angle so the camera continues to fac...